#DIY LIGHT BOX TABLE PROFESSIONAL#
We did a simple setup and shot three different products with the Light Box to show you how it can help you achieve a quality replica of those owned by professional photographers. For this example, we used tracing paper, but you are more than welcome to experiment with others. Tip: Your diffuser panels can be tracing paper, white paper, baking sheets, or any translucent material of your choice. Ensure that there are no folds or stains on the white paper. This creates a photography sweep that is used by professionals to achieve a seamless white background in their product shoot. Tip: You can stitch two white paper sheets together with double-sided tape to clear the box. Step 5: Use double-sided tape to attach the white paper to the top of the back panel.
Step 4: Use a sharp pen knife to cut into the marked out shapes. Step 3: On the exterior of the box, mark out 3cm lines from each edge of the top, left and right panel to create squares for the left and right panels, and a rectangle for the top. Do also try to avoid creases or uneven bumps as it may create unpleasant shadows in your shots. Don’t use clear tape as its glossy surface may cause uneven light reflection and glare onto the subject. Tip: Achieve a matte finish by using double-sided tape to attach the paper to the panels. Step 2: Layer the left, right, top and back panels with white paper. Tip: Try to flatten the back panel as much as possible by using a combination of double-sided tape and clear tape to go around it. Step 1: Choose a side with the outer folds and remove them, then tape down flat the opposite panel of folds. Materials needed: cardboard box, double-sided tape, clear tape, white paper, tracing paper, penknife and ruler.
#DIY LIGHT BOX TABLE HOW TO#
However, the required equipment is professional, bulky and often only found in a photography studio, so it may not always be very cost-friendly.īut what if you could DIY an inexpensive alternative that works? Curious? Check out how to create a DIY Light Box by using common materials such as a light cardboard box, tapes and paper, and see the sample output shots after using it! It also requires diffusers to soften the light sources and retain as much colour integrity and detail, and a photography sweep that helps to achieve a seamless white background. Ever wondered how product catalogues achieve their well-lit output that almost looks like the products have been photoshopped into a white background? The answer lies in the use of different lighting placed at various angles and distances to ensure that the products are well-lit on all sides.
0 kommentar(er)
